العربية
0096522958111

Logo

Find A programme

Power Generation: Steam Turbines, Gas Turbines & Combined Cycle Power Plants

Dates Venues Register
17/01/2027 - 21/01/2027 DOHA

Introduction

Power Generation: Steam Turbines, Gas Turbines & Combined Cycle Power Plants 

 

This comprehensive course covers the design, operation, and maintenance of gas turbines, steam turbines, and combined cycle power plants (CCPP) to enhance efficiency and reliability. Key topics include Brayton/Rankine cycles, heat recovery steam generators (HRSG), turbine controls, maintenance strategies, and troubleshooting. 

Course Outline
Module 1: Introduction to Power Generation 
  • Overview of power generation systems.
  • Fundamentals of Thermodynamic Cycles: Rankine (Steam) and Brayton (Gas) Cycles.
  • Principles of Combined Cycle and Cogeneration. 
Module 2: Gas Turbines (GT)
  • GT components: Compressor, Combustor, Turbine section.
  • Blade design: Materials, coatings, and cooling technologies.
  • Inlet Guide Vanes (IGV) and rotor design.
  • Operation: Starting, loading, and shutdown procedures. 
Module 3: Steam Turbines (ST) 
  • ST Components: HP, IP, and LP rotors.
  • Design Fundamentals: Impulse vs. Reaction blades.
  • Turbine valves, sealing technology, and lubrication systems.
  • Operational dynamics: Turning gear and synchronization.
Module 4: Combined Cycle Power Plants (CCPP)
  • HRSG (Heat Recovery Steam Generator) design and operation.
  • System Integration: Matching GT and ST performance.
  • Operational modes: Single-shaft vs. Multi-shaft configurations.
  • Condensers, deaerators, and feed water systems. 
Module 5: Control, Maintenance & Optimization 
  • Turbine Control Systems (Governing, Protection).
  • Failure Modes & Mitigation: Creep, fatigue, and corrosion.
  • Root Cause Analysis (RCA) and Troubleshooting.
  • Performance Improvement: Efficiency monitoring and emissions control. 

Make an enquiry about seminar

Subject Areas

Locations

Live chat by BoldChat